Search results

Results 1 – 10 of 10
Advanced search

Search in namespaces:

  • *Pulling only 24–25 mA from the charge port. * Bad right I/O board. Unplug it, see if it works (short on 3.3 V or 5 V rail on the I/O board can cause this problem).
    828 bytes (132 words) - 17:48, 8 November 2023
  • Not Charging — Turns on but doesn't charge. Takes ≈0.006 A via USB power meter. ...a screen, battery and charging port to the logic board, then plug it in to charge and check the USB meter.
    7 KB (1,137 words) - 21:20, 20 January 2024
  • '''You can think of a capacitor as a very tiny battery that is able to charge and discharge VERY quickly.''' ...tric field forms between them, storing energy in the form of electrostatic charge. Capacitors can store this energy and release it back into the circuit as n
    9 KB (1,379 words) - 23:19, 26 December 2023
  • ...arged by the Switch brick. If amperage from the charge port is not around .5 amps, try a new battery and check for RCM.
    2 KB (405 words) - 20:30, 13 January 2024
  • File:Xbox360 BatteryForWirelessController.jpg|Xbox360 Plug and Charge kit The controller has a 2.5 mm TRS connector on the front, allowing users to connect a headset for voic
    10 KB (1,426 words) - 21:34, 18 January 2024
  • File:Reviewed Chat pad with play and charge for Xbox One.jpg|Xbox One Wireless Controller with ChatPad ...ility to use Bluetooth Low Energy protocol was added to model 1708 via the 5.11.3116.0 firmware, while model 1914 has support for Bluetooth Low Energy o
    14 KB (2,039 words) - 17:21, 17 January 2024
  • ...ility to use Bluetooth Low Energy protocol was added to model 1708 via the 5.11.3116.0 firmware, while model 1914 has support for Bluetooth Low Energy o |✓ (5)
    13 KB (1,857 words) - 17:28, 17 January 2024
  • ...eezers while still applying heat until the port moves freely. Wait another 5-10 seconds after free movement starts and then slowly lift off the port. Th Ensure the console will charge using both an official Nintendo Switch charger (15v) and a 5v standard char
    5 KB (910 words) - 20:31, 13 January 2024
  • ...dividers are used to monitor the battery voltage to determine its state of charge. "R" on SMD resistors means a dot "." (for example 5R60 means 5.60 Ohms)
    12 KB (1,761 words) - 20:27, 4 March 2024
  • *The power smoothing capacitor inside the device holds quite a charge after the device has been turned off (because the power switch is positione *If there is not a signal, check if U7 has 5V power on pin 5, and a clock signal on pin 14. If both signals are okay, U7 may be broken.
    11 KB (1,986 words) - 21:03, 11 February 2024