We will be continuing maintenance on the wiki starting this Saturday at 9 am (UTC) to Sunday at 7PM (UTC).

There is a possibility of long maintenance-breaks and downtime during this time.

For more information contact us in the wiki Discord or by email at: unto@fighttorepair.org

Epson XP-215/217

From Repair Wiki
Jump to navigation Jump to search

This guide will provide information about the repair of the ink bay of the Epson XP-215/217 printer.

Often times, when replacing ink cartridges, the user may accidentally displace some pins which make contact with the printed circuit of the ink cartridge. This is primarily caused by a defect related to the manufacturing of the cartridge, namely a plastic leftover from the injection molding process that holds the beforementioned printed circuit.

The reader is advised to completely read the guide before attempting any repair.

Material necessary to perform the repair[edit | edit source]

  1. A tweezer.

How to put the pin(s) in place[edit | edit source]

Before starting it is important to open the printer by pulling the upper part up and setting the printer into a "ink replacement" mode. This is easily done by pressing and holding (approximately 7 seconds) the ink/paper button several times, the drawing at the lower right corner might help.

  1. Make sure the bay of which the pin is displaced is empty, ie. there is no ink cartridge inserted.
  2. If the pin have been moved upwards, push it downwards with the tweezer either by the top or the triangle like shape at the bottom. Make sure that the shaft is "hidden" inside the plastic housing. It is quite useful to take out other cartridges (if inserted) as a reference to adjust the displaced pin accordingly.
  3. Inspect the job visually before inserting

Preventing this issue in the future[edit | edit source]

It is often a good practice to visually inspect any foregin element that is going to be inserted into any electronic equipment such as a printer. Therefore, in order to avoid this kind of problem into the future, the cartridge should be inspected and, if necesary, modified before being introduced into the printer. The following steps will describe such modification.

  1. Look at the ink cartridge so that the thin side of the printed circuit of the cartridge is facing towards you.
  2. If you notice that there is some plastic going over the printed circuit, cut it out (either with a knife or a cutter, a sharp scissor will do as well).

Notes[edit | edit source]

  1. While repairing the printer I have accidentally found that touching two or more pins with the metallic tweezer did not cause any damage to the machine, however be careful not to do it to your machine as you might not be as lucky as I was.