IPad Pro 11 Not turning on, drawing no current with little ticking noise repair: Difference between revisions
From Repair Wiki
(Created page with "{{stub}} {{Repair Guide |Device= |Affects parts= |Needs equipment= |Type= |Difficulty= }} ==Problem description== Solving an issue where the iPad 11" 1st gen is not turning on with ticking noise. thumb|C3800 (Figure 1) ==Symptoms== *Ticking noise *Drawing 0A (no current) *Not turning on ==Solution== This specific problem was traced to a shorted line on PMIC/CD3217. The culprit was a shorted cap C3800 (Figure 1). It could also be one (or...") |
m (ASRepairs moved page IPad 11 Not turning on, drawing no current with little ticking noise repair to IPad Pro 11 Not turning on, drawing no current with little ticking noise repair) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{Repair Guide | {{Repair Guide | ||
|Device= | |Device=IPad Pro 11in 1st Gen | ||
|Affects parts= | |Affects parts=Main Logic Board | ||
|Needs equipment= | |Needs equipment=multimeter, soldering iron, soldering station | ||
|Type= | |Type=Soldering | ||
|Difficulty= | |Difficulty=3. Hard | ||
}} | }} | ||
{{stub}} | |||
==Problem description== | ==Problem description== | ||
Solving an issue where the iPad 11" 1st gen is not turning on with ticking noise. | Solving an issue where the iPad 11" 1st gen is not turning on with ticking noise. | ||
Latest revision as of 14:07, 4 February 2024
| IPad Pro 11 Not turning on, drawing no current with little ticking noise repair | |
|---|---|
| Device | IPad Pro 11in 1st Gen |
| Affects part(s) | Main Logic Board |
| Needs equipment | multimeter, soldering iron, soldering station |
| Difficulty | ◉◉◉◌ Hard |
| Type | Soldering |
This article is a stub. You can help Repair Wiki grow by expanding it
Problem description
Solving an issue where the iPad 11" 1st gen is not turning on with ticking noise.
Symptoms
- Ticking noise
- Drawing 0A (no current)
- Not turning on
Solution
This specific problem was traced to a shorted line on PMIC/CD3217. The culprit was a shorted cap C3800 (Figure 1).
It could also be one (or both) the 2 "middle pins connecting from the board to the battery (clk and dat0) that could have been damaged when the battery gets lifted, just make a straight jumper from the motherboard to the battery and that will solve the issue.