iPhone SE (2020)

This article is a stub. You can help Repair Wiki grow by expanding it.

The 2020 iPhone SE was officially marketed as iPhone SE (2nd generation).

Note: When sourcing replacement parts, keep in mind that sources such as iFixit have confirmed that some parts are interchangeable with iPhone 8 parts, including display assembly, rear camera, and taptic engine.

Models	Region
A2275	United States, Canada
A2296	Global
A2298	China

Symptoms:

Problem	Solution
3 Minute Restarting Random Restarting	iPhone SE 2020 models require certain sensors to be detected by the operating system, otherwise it will reboot every 3 minutes & record this error in the panic log. There are 3 sensors that must be detected. On the Charging Port, there is: Mic1 To find the panic log on the device, go to Settings-> Privacy-> Analytics & Improvements-> Analytics Data-> Scroll down to the files starting with "panic-full..." & click on the most top one. Example of a Panic Log Read in more detail here: How To Fix an iPhone SE 2020 That Randomly Restarts
No power, 0.043A on power supply after prompt to boot	Check for missing power rails and loose coils around the CPU and PMIC

FPC Connectors diode mode readings

Use these diode mode maps as a guide to troubleshoot a problem. You must use the RED PROBE on ground and the BLACK PROBE on the pin you are measuring.

For example: you are troubleshooting a no backlight situation, so you probe the pins on the display FPC that correspond to backlight. If a pin says you should read 0.65 and you are reading OL or a short to GND then that's where you need to go.

If instead of getting 0.65 you read 0.58, move on to the next one, remember every multimeter is different and even slight differences in temperature affect this readings. What you are looking for is extreme differences in values, if you are expecting some value and you get a short to ground that is where it is more likely to be your issue.

Display and Touch connector (J1006) & TouchID Home Button connector (J1007)

Diode mode for iPhone SE Display/Touch connector. Pin 1 goes towards top left, pointing to the volume buttons.

iPhone SE TouchID connector. Pin 1 goes towards top left, pointing to the volume buttons.

Charge port / dockflex Connector (J1004)

iPhone SE DockFlex charge port connector. Pin 1 goes towards top left, pointing to the volume buttons.

Battery connector (J1005)

iPhone SE battery connector. Pin 1 goes towards top right, under the rear camera.

Rear camera Connector (J1001)

iPhone SE rear camera connector. Pin 1 goes to the top right of the board, under the rear camera.

Front camera, proximity sensor, earspeaker, ambient light sensor connector (J1002)

iPhone SE front flex connector. Contains front camera, proximity sensor, ambient light sensor, earspeaker. Pin 1 goes towards top Right, under the rear camera.

Volume and Power buttons, flashlight, ringer switch (J1000)

iPhone SE Volume, power buttons, ringer switch and flashlight connector. Pin 1 goes towards top Right, under the rear camera.